Panasonic KX-NS500 Getting Started page 55

To register the IP-PT or KX-UT series SIP phone using the wizard:
For Non-KX-UT Series SIP Phones (including P-SIP)
After connecting non-KX-UT series SIP phones to the PBX over a network, register those IP terminals to the
PBX manually.
Follow the procedure below for registration.
6. For KX-UT series SIP phones only:
Follow the procedure below to change the IP Terminal
Registration Mode from Manual to Full Automatic.
Click Setup ® PBX Configuration ®
a.
Configuration ® Slot ® System Property ®Site
Property ® Main.
b.
In the Main tab, select Full Automatic for IP
Terminal Registration Mode.
c.
Click OK.
2. Click Registration.
A dialogue box will appear. Non-registered (available)
extension numbers and names are displayed on the left.
a.
3.
Highlight numbers and names and click the right
arrow to select them for registration, and then click
Next.
b.
Click Next. A screen will appear with information on
the current IP-PT or SIP phone extension number
and name, and index number for programming.
Note
•
If the IP-PT or SIP phone has been
connected to the LAN and power has been
turned on, the IP address of the PBX will be
assigned automatically.
•
If not, connect the IP-PT or SIP phone to the
LAN and turn the power on within 15 minutes
after this operation is done. The IP address
of the PBX will then be assigned
automatically.
c.
If the registration is still in progress, the dialogue box
will show "Registration Executing".
If the registration is successful, the dialogue box will
show "Registration Completed". Click Close.
Once the IP-PT or SIP phone is successfully
registered, its status will update to show
"Registered".
4.3.2 Registering IP Telephones
Getting Started 55