Parameters Of Analog Output Modules - Siemens SIMATIC S7-400 Reference Manual

5.8.3

Parameters of analog output modules

Overview
Analog output modules use a subset of the parameters and value range listed in the table
below, based on their functionality. For information on subsets "supported" by specific analog
modules, refer to the section dealing with the relevant module.
The default settings apply if you have not set any parameters in STEP 7.
Table 5-42 Parameters of analog output modules
Parameters
Output
● Output type
● Output range
Only in the CR (central rack) is it possible to start up the analog modules with the default settings.
1
See also
Commissioning the SM 431; AI 8 x 14 Bit (Page 247)
S7-400 Automation System Module Data
Reference Manual, Ausgabe 11/2016, A5E00850736-08
Value range
Deactivated
voltage
current
For information on configurable measuring rang‐
es of output channels, refer to the relevant mod‐
ule description.
5.8 Assigning parameters to analog modules
Default set‐ Parameter
ting type
1
U Static
± 10 V
Analog modules
Scope
Channel
203