Router Advertisement (Ra) Guard Commands - D-Link DGS-1510 Series Reference Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
58. Router Advertisement (RA) Guard
Commands
58-1 ipv6 nd raguard policy
This command is used to create an RA guard policy. The command will enter into the RA guard policy
configuration mode. Use the no form of this command to remove an RA guard policy.
ipv6 nd raguard policy POLICY-NAME
no ipv6 nd raguard policy POLICY-NAME
Parameters
POLICY-NAME
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create an RA guard policy. This command will enter into the RA guard policy
configuration mode.
Example
This example shows how to create an RA guard policy named policy1.
Switch# configure terminal
Switch(config)# ipv6 nd raguard policy policy1
Switch(config-ra-guard)#
58-2 device-role
This command is used to configure the role of the attached device. Use the no form of this command
to revert to the default setting.
device-role {host | router}
no device-role
Parameters
host
router
Default
By default, this option is host.
Command Mode
Specifies the IPv6 RA guard policy name.
Specifies to set the role of the attached device to host.
Specifies to set the role of the attached device to router.
519