D-Link DGS-1510 Series Reference Manual page 558

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Usage Guideline
This command controls the sending of SNMP standard notification traps. To enable the sending of
notification traps, the global setting must be enabled too.
Example
This example shows how to enable the switch to send all SNMP traps to the host 10.9.18.100 using
the community string defined as public.
Switch# configure terminal
Switch(config)# snmp-server enable traps
Switch(config)# snmp-server enable traps snmp
Switch(config)# snmp-server host 10.9.18.100 version 2c public
Switch(config)#
This example shows how to enable the SNMP authentication traps.
Switch# configure terminal
Switch(config)# snmp-server enable traps snmp authentication
Switch(config)#
63-8 snmp-server location
This command is used to configure the system's location information Use the no form of this
command to remove the setting.
snmp-server location TEXT
no snmp-server location
Parameters
location TEXT
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the system's location information on the Switch.
Example
This example shows how to configure the system's location information with the string "HQ 15F".
Switch# configure terminal
Switch(config)# snmp-server location HQ 15F
Switch(config)#
Specifies the string that describes the system location information.
The maximum length is 255 characters. The syntax is a general
string that allows spaces.
555