D-Link DGS-1510 Series Reference Manual page 50

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
TEXT
Default
None.
Command Mode
Access-list Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available in the MAC, IP, IPv6, and Expert Access-list Configure mode.
Example
This example shows how to add a remark to the access-list.
Switch# configure terminal
Switch(config)# ip extended access-list R&D
Switch(config-ip-ext-acl)# list-remark This access-list is used to match any IP
packets from the host 10.2.2.1.
Switch(config-ip-ext-acl)# end
Switch# show access-list ip
Extended IP access list R&D(ID: 3999)
10 permit host 10.2.2.1 any
This access-list is used to match any IP packets from the host 10.2.2.1.
Switch#
4-12 mac access-group
This command is used to specify a MAC access list to be applied to an interface. Use the no form of
this command to remove the access group control from the interface.
mac access-group {NAME | NUMBER} [in]
no mac access-group [NAME | NUMBER] [in]
Parameters
NAME
NUMBER
in
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Specifies the remark information. The information can be up to 256
characters long.
Specifies the name of the MAC access list to be applied.
Specifies the number of the MAC access list to be applied.
(Optional) Specifies that the MAC access list will be applied to
check in the ingress direction. If direction is not specified, in is used.
47