D-Link DGS-1510 Series Reference Manual page 413

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
This example shows how to configure the revision level of the MSTP configuration to 2.
Switch# configure terminal
Switch(config)# spanning-tree mst configuration
Switch(config-mst)# revision 2
Switch(config-mst)#
48-4 show spanning-tree mst
This command is used to display the information that used in the MSTP version.
show spanning-tree mst [configuration [digest]]
show spanning-tree mst [instance INSTANCE-ID [, | -]] [interface INTERFACE-ID [, | -]] [detail]
Parameters
configuration
digest
instance INSTANCE-ID [, | -]
interface INTERFACE-ID
,
-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the MSTP configuration and operation status. If a private VLAN is
configured and the secondary VLAN does not map to the same primary VLAN, the show spanning-
tree mst configuration command will display a message to indicate this condition.
Example
This example shows how to display MSTP detailed information.
Specifies to display the table for the mapping relationship between
VLANs and MSTP Instances.
Specifies to display the MD5 digest included in the current MST
configuration identifier (MSTCI).
Specifies to display the MSTP information for the designated
instance only. Define multiple instances by using ',' to specify a
series of instances or to separate a range of instances from a
previous range. Use '-' to specify a range of instances. No space
before and after the comma or hyphen.
Specifies to display the STP information for the specified interface.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
410