D-Link DGS-1510 Series Reference Manual page 559

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
63-9 snmp-server name
This command is used to configure the system's name information. Use the no form of this command
to remove the setting.
snmp-server name NAME
no snmp-server name
Parameters
NAME
Default
By default, this name is "Switch".
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the system's name information on the Switch.
Example
This example shows how to configure the system's name to "SiteA-switch".
Switch#configure terminal
Switch(config)#snmp-server name SiteA-switch
SiteA-switch(config)#
63-10 snmp-server trap-sending disable
This command is used to disable the port's trap sending state. Use the no form of this command to
disable the port's trap sending state.
snmp-server trap-sending disable
no snmp-server trap-sending disable
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Specifies the string that describes the SNMP server name
information. The maximum length is 64 characters. This name
should start with a letter, and end with a letter or a number.
Hyphens are allowed to be used in between the starting and ending
characters. It is recommended not to configure the name longer
than 10 characters.
556