The following numbers refer to Figure 16:
Locking bushing
1
Holder bushing (attached permanently to the probe)
2
HMP110D probe
3
Remote Probe Model
To remove and replace a remote probe:
Unscrew the small sleeve at the end of the probe cable
1
that secures the probe in place, and pull out the probe.
Replace the probe and screw the small sleeve back on,
2
securing the probe tightly in place.
Figure 17: Remote Probe Model
The following numbers refer to Figure 17
Probe cable
1
Sleeve securing the probe to the cable
2
HMP110D probe
3
M211488EN-E
1
1
Removing and Fastening the Probe
2
2
3
3
47