Alarm-Triggered Transmission; Additional Settings; Change Input/Output Scale - Vaisala HMT140 User Manual

Alarm-triggered Transmission

The HMT140 has the ability to initiate a Transmit Attempt
based on an alarm, if this functionality is configured in
viewLinc.
An alarm can be triggered either when the measured value
exceeds a high threshold or goes below a low threshold for a
period of time, as configured in viewLinc.
The HMT140 can also be configured to initiate a Transmit
Attempt when it exits an alarm state. Refer to the Vaisala
Veriteq viewLinc User's Guide for information about alarm
settings.

Additional Settings

Change Input/Output Scale

If you want your HMT140 to provide more meaningful
output measurement units, you can modify the output
settings (if you are not sure if your network requires/
supports this option, contact Vaisala Technical Support for
assistance).
To modify input/output values:
From the Setup tab, select the I/O Definition tab.
1
Enter the HMT140's input range values.
2
Enter required Display Units, the number of decimal
3
places you want recorded, the high/low output values
and desired measurement units.
M211488EN-E
Additional Settings
35