Vaisala HMT140 User Manual page 31

The status bar is located at the bottom of the HMT140
Utility window. It contains the following panels:
• Left panel: Displays the Configuration Cable status:
• Middle panel: Displays progress messages of the
• Right panel: Displays a message when the
If the IP address is static, uncheck the IP Address
8
Dynamically Assigned option and enter the network
parameters. Otherwise leave this checkbox checked.
Note:
Enter the parameters for the WLAN (wireless LAN
9
router settings).
Enter the Destination IP address/name and port
10
number of the host (these are the Vaisala viewLinc server
settings) to which the HMT140 will send information.
Note:
Click the Sensor tab and select a Transmit Period
11
Time and number of Tries, or accept the default
settings.
Click Update.
12
Click the Status tab to check that the settings appear as
13
configured. Click Get if the settings do not appear
automatically.
Disconnect the HMT140 Configuration Cable from the
14
HMT140 and wait for eight seconds.
Press the SERVICE button inside the HMT140.
15
Optional:
Setup tab in the Saved Settings field, then click the
disk icon to save. To configure custom settings for the
HMT140, refer to page 28. To configure additional
HMT140 data loggers, refer to the Vaisala viewLinc
User's Guide.
M211488EN-E
Found USB Programmer or Looking for USB
Programmer.
different actions: Update, Retrieve, Status, and Info.
parameters on the Setup page have been modified and
require saving.
For additional IP address settings information
see, Check Transmission status on page 31.
If you do not know what information to enter for
steps 6-9, please request these parameters from
your network administrator.
Enter a name for the saved settings on the
Connecting to your Network
27