Vaisala HMT140 User Manual page 30

Connecting to your Network
Turn on the HMT140 and wait five seconds to ensure the
2
startup process completes.
Plug the USB connector on the HMT140 Configuration
3
Cable to the computer, if it is not already connected.
From the start menu, open the HMT140 Utility.
4
Connect the end of the Configuration Cable labelled USB
5
Wi-Fi Programmer, to the 4-pin HMT140 CONFIG
header.
On the HMT140 Setup tab, click Retrieve to identify
6
the HMT140. The bottom left status bar will initially
read, Looking for sensor or USB programmer,
then, once the HMT140 is identified, the status bar will
read, Found USB Programmer.
Click Retrieve again to force retrieval of current
7
settings.
Note:
26
The connected type is identified in the upper
right corner of the Setup tab window.
VAISALA