The following numbers refer to Figure 1:
HMT140 enclosure
1
Cable bushing: cable gland.
2
Probe cable
3
HMP110D probe
4
Plastic grid filter
5
Installation Kit
The HMT140 is typically installed mounted on the wall with
up to four screws (not included). See Figure 2 on page 15.
For duct mounting, Duct Installation Kits are available as
accessories. See Options and Accessories, on page 9.
To help you position the screws correctly, use the Drilling
Template, available inside the back cover of the Quick Guide.
HMT140 Utility and Configuration Cable
To connect an HMT140 to your network, you will need to
install the HMT140 Utility software and connect the
HMT140 to your PC with the configuration cable (see,
Connecting to your Network, on page 24).
M211488EN-E
Introduction to the HMT140
11