Nexcom VTC 7200-BK User Manual page 95

Appendix F: OBDII Module Setup and Command
B7 B6 B5
NOT USED
B7: 1, Total Vehicle Distance is provided by vehicle ECU
0, Total Vehicle Distance is calculation value
B3~B0:
0000 start not requested
0001 starter active, gear not engaged
0010 starter active, gear engaged
0011 start finished; starter not active after having been actively
engaged ?
#12
(after 50ms mode goes to 0000)?
0100 starter inhibited due to engine already running
0101 starter inhibited due to engine not ready for start (preheating)
0110 starter inhibited due to driveline engaged
0111 starter inhibited due to active immobilizer
1000 starter inhibited due to starter over-temp
1001-1011 Reserved
1100 starter inhibited - reason unknown
1101 error
1111 not available
Axle location The value 0xFF indicates not available.
B7 B6 B5
Axle location Bit-mapped position
number counting front to back facing
forward
#13
F = not available
position number, counting front to
back on the vehicle. B7,B6,B5,B4
Axle location Bit-mapped position
number counting front to back facing
forward.
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
B4 B3 B2 B1
Engine Starter Mode
B4 B3 B2 B1
Tire location Bit-mapped counting left
to right facing forward
F = not available
The low order 4 bits represent a
position number, counting left to right
when facing in the direction of normal
vehicle travel
#14 Axle weight 0.5 kg / Bit gain (Low Byte),AWL
B0
Axle weight 0.5 kg / Bit gain (High Byte), AWH
#15
Weight=(AWH*256+AWL)*0.5
#16 Engine total hours of Operation, EH1
#17 Engine total hours of Operation, EH2
#18 Engine total hours of Operation, EH3
Engine total hours of Operation, EH4
#19 Accumulated
time=((EH4*256*256*256)+(EH3*256*256)+(EH2*256)+EH1)*0.05
#20 Vehicle identification number, aabbccddeeffgghh (If the Vehicle ID
| contains more than 8 Bytes then #20~#27 are "00", please use ATI
#27 command to request.
#20 aa
#21 bb
#22 cc
#23 dd
#24 ee
#25 ff
#26 gg
#27 hh
#28 Engine Percent Load At Current Speed ( 0~125 %)
B0
#29 SW-version supported for trucks, Version number in the format
| ab.cd where this byte represents ASCII code #29 : "a" , #30: 'b',
#32 #31:'c' , #32:'d'
#33
High Resolution Total Vehicle Distance, 5 m/bit, 0 to 21,055,406 km
|
=((D4*256*256*256)+(D3*256*256)+(D2*256)+D1)*0.005 (KM)
#36
#33 D1
#34 D2
81
VTC 7200-BK Series User Manual