Toyota Highlander Service Manual page 292

292
4-5. Using the driving support systems
Canceling and resuming the speed control
Pulling the lever toward you
1
cancels the speed control.
The speed setting is also canceled
when the
depressed.
Pushing the lever up resumes
2
the cruise control and returns
vehicle speed to the set speed.
However, cruise control does not resume when the vehicle speed is
approximately 25 mph (40 km/h) or less.
Approach warning (vehicle-to-vehicle distance control mode)
When your vehicle is too close to
a vehicle ahead, and sufficient
automatic deceleration via the
cruise control is not possible, the
display will flash and the buzzer
will sound to alert the driver. An
example of this would be if
another driver cuts in front of you
while you are following a vehicle.
Depress the
ensure an appropriate vehicle-to-
vehicle distance.
Warnings may not occur when
■
In the following instances, warnings may not occur even when the
vehicle-to-vehicle distance is small.
● When the speed of the preceding vehicle matches or exceeds
your vehicle speed
● When the preceding vehicle is traveling at an extremely slow
speed
● Immediately after the cruise control speed was set
● When depressing the accelerator pedal
HIGHLANDER_U (OM0E017U)
brake pedal is
brake pedal to