Generator Pop-Up Menu (Diagnostics Monitor Display); Config Menu - Tektronix WFM2200A User Manual

Generator pop-up menu
(Diagnostics Monitor
display)

CONFIG menu

WFM2300 and WFM2200A Waveform Monitors User Manual
Elements on page 4. The following instrument diagnostic information appears on
page 4 of the display: See
■ External Power & Battery Information: Shows the status of various
parameters related to the operation of the battery pack. If a battery pack is not
installed in the instrument, the Status readout shows "Not Present" and the
diagnostic parameters will list "N/A" as the status.
Press and hold the GEN button to open the Generator pop-up menu. The
following menu selections are available:
Display type. Select from the following display types:
■ Video Generator Status – Displays the status of video signals being
generated by the instrument. See
page 144.
■ Audio Generator Status – Displays the status of audio signals being
generated by the instrument. See
■ Diagnostics Monitor – Displays the status of various instrument diagnostics.
The diagnostic information that is viewed from the Diagnostics Monitor displays
is different than the diagnostics that are run when the instrument is powered on.
You can use the CONFIG menu to view and configure the following Diagnostics
Log parameters:
■ Use the Alarms > System and Diagnostics setting to enable an alarm for a
hardware fault.
■ Use the menu selection under Utilities to run diagnostics, to set how the
diagnostics log responds when full, to view the diagnostics log, and to
configure custom diagnostics.
Diagnostics Monitor display
Video Generator Status display
Audio Generator Status display
Display modes
on page 86.
on
on page 65.
89