Unpack and Installation
Connect DC18~20V power source using the included power cord.
4.
Connect the power cord to the power interface.
5.
Fasten the power protect accessory.
6.
As a final step, turn on the device by pressing the corresponding
7.
power switch located on the front panel.
The pedestal and the monitor are packaged separately.
Connect a standard signal line to the corresponding input port. All BNC
connector impedance must be 75Ω.
Please use the power cord supplied to avoid unnecessary trouble, and
make sure be well grounded.
The factory default value for IP address is 192.168.1.86.
Installation Methods:
The MVM-200 monitor could be mounted to a monitor stand or mounted to a
cabinet or onto a wall. The MVM-170 monitor could be mounted to a monitor
stand or mounted to a cabinet.
Monitor Stand Installation
8