Each display screen of the MVM230 is an independent professional monitor. So it can achieve the various professional parameters and can be adjusted independently, including GAMMA, color temperature, brightness, and so on.
Page 5
User Manual MVM230 Quad Split LCD Monitor Support high-quality waveform, vector monitoring Support HDMI output or HD-SD display, can achieve the cascade and copy output of devices MARKER, Time Code, MET display Pre-set the color temperature, user-adjustable color temperature...
User Manual MVM230 Quad Split LCD Monitor Chapter 2 Safety Precaution for Use FCC Caution Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules.
Page 7
User Manual MVM230 Quad Split LCD Monitor Read and keep these instructions. Heed all warnings. Follow all instructions. About the Position Do not block any ventilation openings. Do not use this unit near water. Do not expose the unit to rain or moisture.
1. Install the base. Installation 2. Put the MVM230 on the position you need for installing, and connect the power. Please make sure the place you put is safety. 3. Connect a standard signal lines to the corresponding input port. All BNC connector impedance must be 75Ω.
User Manual MVM230 Quad Split LCD Monitor 19V adapter electric Power cord accessory Base board with screws Chapter 4 Description of product structure Front panel (Unit: mm) Rear panel (Unit: mm) —7—...
Page 10
User Manual MVM230 Quad Split LCD Monitor Side view (Unit: mm) Top view (Unit: mm) —8—...
User Manual MVM230 Quad Split LCD Monitor Chapter 5 Usage 5.1 Description for Display status Status information: Displayed in the upper left corner of each window, including the input channel number and signal format. TC code: Display Format: HH: MM: SS: FF and if there is no TC code, display --:--:--:--.
Page 12
User Manual MVM230 Quad Split LCD Monitor Four-screen, full 16-channel audio meter One-big and with three-small screen, full 16-channel audio meter —10—...
User Manual MVM230 Quad Split LCD Monitor Waveform and vector display: Display in the screen. (Only for CH1 and CH2.) As below. 5.2 Signal Format Video input signal: 4 adaptive CVBS, SD/HD/3G-SDI video (supports embedded audio) and one DVI -D/ HDMI (as the same as IN1).
User Manual MVM230 Quad Split LCD Monitor Note: The specs are subject to change without prior notice. Right of the rear panel: 5.4 Interface of front panel Headphone port Detail 1~4: Channel 1-4, switch to full screen for CH, and press the key again, the screen will return to quartered screen.
User Manual MVM230 Quad Split LCD Monitor key for a moment, the settings will restore to default settings. 7: MENU, enter the menu item. Or press this key for a moment; the startup logo setup menu will appear. 8:DOWN/F1, function key and DOWN. And the function key is only active for the selected channel.
Page 17
User Manual MVM230 Quad Split LCD Monitor 4- Parameter information of the items. Changes the item setup parameter of the item you selected, press ENTER and it will also save your setup. If you don’t want to change the parameter, press MENU to turn back to the previous menu. The item selected will be yellow and when the character is white it can be changed and when the character is blue it cannot be changed.
Page 18
User Manual MVM230 Quad Split LCD Monitor STATUS COLOR TEMP ASPECT MODE NONE SCAN MODE OVER IP ADDRESS 192.168.1.1 SUBNET MASK 255.255.255.0 SERIAL NO. MVM23020110801 MODEL MVM230-H This item displays the monitor information, and the parameters cannot be adjusted. And maximum 9 items in one page.
Page 19
User Manual MVM230 Quad Split LCD Monitor GREEN GAIN, BLUE GAIN, RED BIAS, GREEN BIAS, BLUE BIAS and RESET can be adjusted. RED GAIN 128 <0-255> GREEN GAIN 128 <0-255> BLUE GAIN 128 <0-255> RED BIAS 32 <0-64> GREEN BIAS 32 <0-64>...
Page 20
User Manual MVM230 Quad Split LCD Monitor <2.35:1> CENTER MARKER OFF <ON> marker displayed <OFF> marker not displayed SAFETY MARKER OFF Setting the picture safe area marker which is in the area of AREA MARKER. <OFF> <80%> <85%> <88%> <90%>...
Page 21
User Manual MVM230 Quad Split LCD Monitor <EXT> <EBD> SPEAKER L EBD CH1 Select the embedded audio channel to the left speaker and line out <OFF> <EBD CH1 – CH16> SPEAKER R EBD CH2 The same as above OFF <OFF>...
Page 22
User Manual MVM230 Quad Split LCD Monitor Sub Menu Settings Explanation USER CONFIG BACKLIGHT 13 Adjusts the backlight <0 ... 30> LANGUAGE ENGLISH <ENGLISH>: English <中文>: Chinese PHASE (NTSC only) 50 <0 ... 100> APPERTURE 20 <0 ... 63> F1 BUTTON MARKER <MARKER>: Control all MARKERS.
Page 23
User Manual MVM230 Quad Split LCD Monitor OSD CONFIG -NEXT PAGE -IMD DISPLAY - IMD COLOR -IMD CHAR MVM230-H -TC DISPLAY -WAVE FORM -WAVE OVER LIMIT -WAVE UNDER LIMIT -FORMAT DISPLAY AUTO Sub Menu Settings Explanation OSD CONFIG NEXT PAGE - For turning to the next page.
Page 24
User Manual MVM230 Quad Split LCD Monitor OFF <OFF> <CC1> <CC2> <CC3> <CC4> <TEXT1> <TEXT2> <TEXT3> <TEXT4> <XDS> 1. Only channel 1 and 3 have wave form and vector functions. 2. CC is inactive. PAGE 2:IMD DISPLAY OSD CONFIG...
User Manual MVM230 Quad Split LCD Monitor Display. Press ENTER to edit the IMD name, Use UP and DOWN to select characters, Press ENTER to go to next cursor, Press MENU to exit editor. BAUD RATE 19200 9600/19200/38400 TSL V3.1 and TSL V4.0 is 38400, Image video is one of the 9600/19200/38400.
User Manual MVM230 Quad Split LCD Monitor 6.3 Adjustment menu Press ENTER to enter the adjustment menu. It includes VOLUME, BRIGHTNESS, CONTRAST, and CHROMA. It displays as follow: Press UP and DOWN to adjust the parameter of the current item and press ENTER to enter the next item of the adjustment menu.
User Manual MVM230 Quad Split LCD Monitor All images show the biggest screen in center under the premise of keeping the same aspect ratio. IMD, audio level meter and other kinds of information show in the window without affecting the image display.
User Manual MVM230 Quad Split LCD Monitor Impedance 75 ohms Return Loss >40 dB 到 5 MHz DC Offset 0V±0.05 V Frequency Response ±0.2 dB to 5 MHz Differential Gain <1% Differential Phase <1.5° 3G-SDI /HD-SDI /SDI-SDI Input/ Output: Signal Type...