Upgrading The Software In The Tdp-T3 - Toshiba TDP-S3 Service Manual

Upgrading the software
To upgrade the software, you need the M1-A cable (210-0185-xx) that ships with the
projector. You also need to download the software (page 60) and install the software on your computer
(page 61).
Special Note Before you begin the software upgrade process, make sure that you have properly loaded
into your computer the system software and drivers included in the software you
downloaded from the Toshiba web site. Otherwise the upgrade will not work.
Connect the projector to the computer with the M1-A cable
1 Plug the M1-A cable into the projector and computer as shown in the illustration below. You don't
need to plug in the monitor cable.
2 Plug the power cord into the projector and into a power source.
NOTE The instructions below apply to both the TDP-S3, the TDP-T3 and the TDP-MT5. The
TDP-T3 is referenced in the examples, but they apply to the TDP-S3 Mt-5 as well. The only
difference is that the three projectors use different software.
3 Open Windows Explorer, navigate to the batch file, then double-click the FlashUSB utility.
TDP-S3/TDP-T3/TDP-MT5 Service Manual 64