Remove and replace the top case
The top case (TDP-S3/T3: 505-0982-xx; TDP-MT5: 505-1188-xx) covers the top half of the half of the
projector. Once you remove the top case, you have access to FRUs inside the projector. A new top case
also includes the IR ECA and cable.
1
Remove the following items:
Front bezel and front bezel vent (see page 13)
Focus and zoom rings (see page 11)
2
Place the projector on its top, and then remove the black M3x48 cone point Torx screw at the rear
of the bottom case. The front screw was taken out when you removed the front bezel.
3
Place the projector right side up.
TDP-S3/TDP-T3/TDP-MT5 Service Manual
20