Remove And Replace The Rear Bezel - Toshiba TDP-S3 Service Manual

Remove and replace the rear bezel

The rear bezel (TDP-S3/T3: 505-0966-xx; TDP-MT5: 505-1129-xx) fastens to the metal chassis. The rear
bezel label (020-1177-xx) adheres to the outside of the rear bezel.
When you access the rear bezel, you also remove the power supply insulator (TDP-S3/T3: 329-0268-xx
TDP-MT5: 329-0321-xx), the diode gap pad (329-0301-xx), and the diode heat sink bracket (330-0724-
xx). These three parts provide thermal and electrical protection for the power supply.
1 Remove the chassis and power supply from the bottom case (see page 36).
2 Remove the power supply from the chassis (see page 48).
3 Place the chassis on the work surface so that the paper power supply insulator faces upward.
4 Remove the M3x6 Torx screw that secures the diode heat sink bracket to the chassis, then
remove the heat sink and attached gap pad.
5 Remove the gap pad. Place it in a secure location so that it does not get lost.
TDP-S3/TDP-T3/TDP-MT5 Service Manual 40