Toshiba TDP-S3 Service Manual page 18

4 Swing the bail on the top of the lamp module up from its storage position, and then pull the
module out of the projector.
Assembly Notes
♦
The lamp must be seated properly to fully ignite.
♦
Torque the two captive screws to 6 in.-lbs. (.678 Nm).
♦
Make sure the bail on the lamp module is folded down in storage position. It snaps into position.
♦
You must replace the lamp door for the projector to operate.
TDP-S3/TDP-T3/TDP-MT5 Service Manual 18