Remove and replace the bottom case
The bottom case (505-0970-xx) encloses the bottom half of the projector. A new bottom case also
includes the rubber foot, elevator, leveling foot, light block louver and the engine mount spacer. When you
replace a bottom case, you also need to adhere a new certification label (TDP-S3: 020-1271-xx; TDP-
T3: 020-1165-xx; TDP-MT5: 020-1350-xx).
1
Remove the chassis and power supply (page 36) and the optical engine (page 57) from the
bottom case.
2
Place the chassis on the work surface so the outside faces upward.
3
Remove the serial number label. To do this, carefully use a heat gun or hair drier to soften the
adhesive on the back of the label, then peel it off. Do not lose the serial number. It is not a
replaceable part.
Assembly Note
♦
Adhere a new certification label to the bottom case. Then adhere the original serial number label in
the box near the leveling foot.
TDP-S3/TDP-T3/TDP-MT5 Service Manual
59