Once you remove the power supply, the parts pictured below remain attached to the chassis.
The paper power supply insulator (329-0268-xx), the front gap pad (329-0302-xx), the rear
gap pad (329-0301), and the heat sink bracket (330-0742-xx) are all replaceable parts. These
parts ensure that power supply components do not short out or overheat during projector
operation.
All parts must be in place before the power supply is fastened to the chassis. For removal and
replacement instructions, see rear bezel on page 40.
NOTE
The gap pad may stick to the bottom of the power supply when you remove it. Make sure
you replace the gap pad if it comes off of the chassis.
TDP-S3/TDP-T3/TDP-MT5 Service Manual
50