Assembly Notes
♦
If you are installing a new rear bezel, affix a new rear bezel label (020-1137-xx) to the outside of the
bezel.
♦
If you are replacing the rear bezel on the TDP-MT5, you also need to adhere the I/O EMI shield
gasket (329-0362-xx) and the top I/O EMI gasket (329-0361-xx) to the bezel. See the illustrations
below.
♦
To mount the rear bezel on the chassis, align the two tabs on the inside of the bezel with the two
recesses on the chassis. Alignment pins in each recess engage holes in each tab. Torque the two
M3x8 Torx screws to 6 in/lbs (.68 Nm)
TDP-S3/TDP-T3/TDP-MT5 Service Manual
42