6
Place the top case next to the projector, and then disconnect the keypad cable from the ZIF
connector on the controller ECA and the IR cable from its connector.
7
If you are going to replace the top case with a new one, remove the keypad (see page 23).
Assembly Notes
♦
If you're replacing the top case with a new one, install the keypad on the inside of the case (see page
23).
♦
Connect the keypad and IR cables first. Then engage the hinges on the lens side of the projector.
♦
Swing the top case shut, making sure that it fits flush over the bottom case.
♦
Torque the black M3x48 cone point Torx screw to 4 in.-lbs. (.452 Nm)
TDP-S3/TDP-T3/TDP-MT5 Service Manual
22