Advertisement
KS-FX772R
Removing the mode gear
1.
Remove the polywasher on the bottom and pull out
the mode gear.
Removing the mode switch actuator
1.
Pull out the mode switch actuator at the bottom.
REFERENCE:
When
actuator to the main chassis, make sure to
set on the shaft and insert v into the slot w.
Removing the direction link / direction
plate (See Fig.29 to 31)
1.
Remove the polywasher attaching the direction link.
2.
Bring up the direction link to release the three joints
x, y and z at a time.
3.
Move the direction plate in the direction of the arrow
to release the two joints a'.
REFERENCE:
When reattaching the direction plate,
engage the two joints a' and move in the
direction of the arrow (Refer to Fig.30).
REFERENCE:
When reattaching the direction link,
move the direction plate in the direction
of the arrow and engage the three joint
x, y and z at a time (Refer to Fig.31).
Removing the mode rack assembly
1.
Move the mode rack assembly in the direction of the
arrow to release the two joints b' and the joint c'.
REFERENCE:
When reattaching, set the two b' on the
bottom of the mode rack assembly into the
slots of the main chassis and move in the
direction of the arrow (See Fig.30).
1-14
(See Fig.28 and 31)
(See Fig.28, 29 and 31)
reattaching
the
mode
(See Fig.29 and 30)
Mode switch actuator
Direction plate
switch
Direction plate
Joints a'
Joint z
Direction link
Direction plate
Joints a'
Direction link
Direction plate
Mode gear
Polywasher
Direction link
Fig.28
Mode rack assembly
Slot w
Joint y
Joint x
Polywasher
Fig.29
Mode rack assembly
Joint b'
Fig.30
Mode switch actuator
Polywasher
v
Mode gear
Mode rack assembly
Fig.31
Joint b'
Joint c'
Advertisement
