Advertisement
KS-FX772R
Disassembling the flywheel assembly (F)
1.
Push and turn counterclockwise the spring holder (F)
to release the three joints p on the bottom of the
flywheel.
2.
The spring holder (F), the TU spring and the friction
gear play come off.
3.
Remove the polywasher and felt.
Disassembling the flywheel assembly (R)
1.
Push and turn clockwise the spring holder (R) to
release the three joints q on the bottom of the
flywheel.
2.
The spring holder (R), the FF spring and the friction
gear FF come off.
3.
Remove the polywasher and the felt.
Removing the reel board
1.
Remove the two screws C attaching the reel board.
2.
Move the reel board in the direction of the arrow to
release the joint r.
3.
Unsolder the wires if necessary.
CAUTION:
When reattaching, confirm operation of
the MODE switch and the ST-BY switch.
The mode position between EJECT and
ST-BY is optimum for reattaching.
Connect the card wire extending from
the reel board to the FFC pad before
reattaching the reel board.
C
1-12
(See Fig.20 and 21)
(See Fig.20 and 22)
(See Fig.23 and 24)
FFC pad
Reel board
C
Fig.23
Flywheel assembly (F)
Joints p
Joint p
Polywasher
Spring holder (F)
TU spring
Friction gear play
Flywheel assembly (F)
Fig.21
Joint r
Flywheel assembly (R)
Joints q
Fig.20
Polywasher
Spring holder (R)
FF spring
Friction gear FF
Felt
Felt
Flywheel assembly (R)
Fig.22
FFC pad
CT-1 switch
MODE switch
Soldering
ST-BY switch
Fig.24
Joint q
Advertisement
