Sun Microsystems StorEdge T3+ Installation And Configuration Manual page 12

Dual Hosts With Two Hubs and Eight Controller Units Configured as Four Partner
FIGURE 4-11
Groups 47
Dual Hosts With Two Switches and Two Controller Units 49
FIGURE 4-12
Dual Hosts With Two Switches and Eight Controller Units 51
FIGURE 4-13
Sun StorEdge T3+ Array Cables 55
FIGURE 5-1
Removing the Front Panel 56
FIGURE 5-2
Serial Number and MAC Address on Pull-out Tab 56
FIGURE 5-3
Sun StorEdge T3+ Array Cables 66
FIGURE 6-1
Connecting the Fiber-Optic Cable to the FC-AL Connector on a
FIGURE 6-2
Sun StorEdge T3+ Array 67
Connecting the Ethernet Cable 67
FIGURE 6-3
Connecting the Power Cords 68
FIGURE 6-4
Connecting the Interconnect Cables 69
FIGURE 6-5
Fully Cabled Partner Group (Enterprise Configuration) 70
FIGURE 6-6
Power and Cooling Unit LEDs and Power Button Location 71
FIGURE 6-7
Disk Drive Physical Numbering 82
FIGURE 6-8
Power Switch Locations 95
FIGURE 6-9
Level 3 Firmware Version Check Output for Master Unit
FIGURE 7-1
Level 3 Firmware Version Check Output for Master Unit
FIGURE 7-2
Sun StorEdge T3+ Array Partner Group 136
FIGURE 10-1
Sun Enterprise 6x00/5x00/4x00/3x00 SBus+ I/O Board 140
FIGURE 11-1
Sun StorEdge PCI FC-100 Host Bus Adapter 141
FIGURE 11-2
Sun StorEdge SBus FC-100 Host Bus Adapter 142
FIGURE 11-3
Sun StorEdge PCI Single Fibre Channel Network Adapter 143
FIGURE 11-4
Sun StorEdge PCI Dual Fibre Channel Network Adapter 144
FIGURE 11-5
Sun StorEdge CompactPCI Dual Fibre Channel Network Adapter 145
FIGURE 11-6
Sun StorEdge T3+ Array Controller Card and Interconnect Cards 149
FIGURE 12-1
Array Workgroup Configuration 150
FIGURE 12-2
Enterprise Configuration 151
FIGURE 12-3
Disk Drive LEDs (Viewed Through Front Cover) 157
FIGURE 13-1
Power and Cooling Unit LEDs 158
FIGURE 13-2
xii Sun StorEdge T3+ Array Installation and Configuration Manual • April 2002
103
111