To Configure the Workgroup
To display and mount the default volume of a single controller unit:
1. On the array, type vol stat to check the status of the volume.
:/:<2> vol stat
v0
u1d1
unmounted
0
Where:
v0 is the name of the volume.
unmounted is the status of the volume.
u1d1–u1d9 are the disk drives in the volume.
0 is the status of the disk drives in the volume.
All the disk drives should show a status of 0. Other possible status messages are
listed in the following table.
TABLE 6-1
Value
0
2
3
4
5
7
9
D
S
If the vol stat output shows the volume as mounted, skip to Step 4.
If the vol stat output shows the volume as unmounted, proceed to Step 2.
2. Use the vol mount command to mount the volume.
:/:<3>vol mount volume-name
u1d2
u1d3
u1d4
0
0
0
Drive Status Messages
Description
Drive is mounted
Drive is present
Drive is spun up
Drive is disabled
Drive has been replaced
Invalid system area exists on drive
Drive is not present
Drive is disabled and is being reconstructed
Drive is substituted
u1d5
u1d6
u1d7
0
0
0
Chapter 6 Array Installation
u1d8
u1d9
0
0
83
Need help?
Do you have a question about the StorEdge T3+ and is the answer not in the manual?