Sun Microsystems StorEdge T3+ Installation And Configuration Manual page 100

Sun StorEdge T3+ array level 2 controller firmware, the level 2 image is 0200.
5. Refer to the SunSolve web site at http://sunsolve.sun.com for the latest
firmware release information:
a. In the SunSolve Online column, click on Patches.
b. In the Patches column, click on PatchPro.
c. Click on Storage Products.
Refer to the patch README file for details on firmware and specific firmware patch
requirements.
Note – If you do not have access to the SunSolve web site, contact your SunService
provider for patch information.
6. If you need to upgrade the firmware, do so now by following the instructions in
Chapter 7.
If you do not need to upgrade firmware, proceed to Step 7.
7. Type port list to display how the paths are mapped from the host to the
volumes.
An example of port list output for a single controller unit:
:/:<7>port list
port targetid
u1p1 1
Use the world wide name (wwn) from the port list output to map the volume to
the Solaris environment using the format(1M) utility on the data host. In the
following example, the output for the format command shows the same wwn,
listed in the last line, as the wwn in the port list output.
# format
Searching for disks...done
AVAILABLE DISK SELECTIONS:
78 Sun StorEdge T3+ Array Installation and Configuration Manual • April 2002
addr_type status
hard online
0. c0t0d0 <SUN4.2G cyl 3880 alt 2 hd 16 sec 135>
/pci@1f,4000/scsi@3/sd@0,0
1. c2t1d0 <SUN-T300-0113 cyl 34145 alt 2 hd 64 sec 128>
/pci@6,2000/SUNW,ifp@1/ssd@w50020f23000002ba,0
host wwn
sun 50020f23000058de