Datavideo HDR-1 Instruction Manual page 51

16 Why is recording interrupted?
17 Why does the record LED start to
flash rapidly during recording?
18 Why is the audio and video of the
recorded content out-of-sync?
19 The HDR-1 fails to record when
the source contains multiple
audio channels.
20 Can the HDR-1 record 5.1
channels of high-quality audio?
21 Why can't the system detect the
firmware during the upgrade
process?
This means that the HDR-1 has detected
that the write performance of your
storage device is extremely poor, which
is the direct cause of interrupted
recording. Hence we recommend an
NTFS hard disk replacement.
When the record LED starts to flash
rapidly, it means your storage device will
be used up very soon. Recording could
stop in a few minutes after the storage
space is depleted. Please find a new hard
disk replacement before recording stops.
While the recording is in progress, if the
HDMI input is disconnected, the
recording will stop. After the input is
reconnected and restored, the HDR-1 will
start to record again, but the audio and
video of the content recorded will
become out of sync.
The HDR-1 currently supports dual audio
channel recording only and will fail to
record if multiple audio channels such as
Dolby, DTS and etc are detected.
The HDR-1 can only record two audio
channels so if the signal source is of
multiple audio channels, the HDR-1 still
records two audio channels only.
Please check if the firmware file is still on
the thumb drive. This is because if the
HDR-1 detects that the thumb drive is
not safely removed on the PC, the system
will display a repair message and the
firmware file will be removed (previously
recorded file will NOT be deleted) after
the thumb drive is repaired.
51