Lectrosonics SSM Instruction Manual page 15

Step 3:
Refer to Step 1 to return to Firmware web page. Down-
load Firmware Update and save to a local file on your
PC for easy locating when updating.
Step 4:
Open Lectrosonics USB Firmware Updater.
Step 5:
Step 6:
Using a microUSB cable, connect the transmitter to
your PC.
Rio Rancho, NM
Put the transmitter in UP-
DATE mode by simultane-
ously holding down the UP
and DOWN arrow buttons on
the transmitter control panel
while powering it up.
Micro Body Pack Transmitter
Step 7:
In Lectrosonics USB Firmware Updater, choose the
detected device, browse to local Firmware File and
click Start.
NOTE: It may take up to a minute or so for the
Updater to recognize the transmitter.
WARNING: Do not disrupt the microUSB cable
during updating.
The Updater alerts with progress and completion.
Step 8:
Step 9:
Close Updater and disconnect microUSB cable.
Once the Updater has
completed, turn off the
transmitter, then turn it back
on to verify that the firmware
version on the transmitter
LCD matches the firmware
version shown on the web
site. The firmware is the
second LCD display during
boot up sequence.
15