Makita RP2300FC Technical Information page 15

W
iring diagram
Fig. D-3B
Support unit
Controller
Put Controller into
the above illustrated
position.
Support unit's Lead wire (orange)
Connect Insulated connector to
Switch terminal 2 while keeping
it away from Boss.
Switch terminal 2
Insulated connector
RP2300FC with LED Job Light, Electronic Control
Wiring in Motor housing
on top side (Rear cover side)
Support unit's Lead wire (black)
RP2300FC with LED Job Light, Electronic Control
Wiring in Grip R
Lead wire holder
When putting Support unit's Lead wires
into Lead wire holders, put them as follows.
* Support unit's Lead wire (black)
into Lead wire holder of outside
* Support unit's Lead wire (orange)
into Lead wire holder of inside
Boss
P 15/ 27