Removing The Server From The Rack - HP ProLiant ML350 Generation 4 Maintenance And Service Manual

18 HP ProLiant ML350 Generation 4 Server Maintenance and Service Guide
1. Power down the server ("Powering Down the Server" on page 15).
2. Remove the front bezel, if necessary ("Removing the Front Bezel (Tower
Model)" on page 19).
3. Loosen the two thumbscrews on the front panel of the server near the access
panel.
4. Slide the access panel back about 1.5 cm (0.5 in).
5. Lift and remove the access panel.
To replace the component, reverse the removal procedure.

Removing the Server from the Rack

To remove the server from an HP, telco, or third-party rack:
1. Power down the server ("Powering Down the Server" on page 15).
2. Loosen the front panel thumbscrews that secure the server faceplate to the
front of the rack.
3. Disconnect the cabling and remove the server from the rack. Reverse the
server installation steps in the documentation that ships with the rack-
mounting option.
4. Place the server on a sturdy, level surface.
NOTE: Turn the access panel over to locate the System Configuration
and Options hood labels. These labels will provide information on
installing various options, flexible memory configurations, LED status
indicators, and switch settings.