Toe-In; Toe-In - Branson 00 Series Operator's Manual

7
0 BraNsON 00 sErIEs
-
CAUTION
•
Carry out inspection or main-
tenance after the engine if ful-
ly cooled down.
[Otherwise]
There is a risk of getting burnt.

TOE-IN

F
B
a
r
(F) Front (r) rear
► CHECKING
If the toe-in is not properly aligned,
the steering wheel may be uncon-
trollable or the tractor may produce
an abnormal vibration. measure the
distance a and the distance B of the
front wheels and see if the different
between the two measurements is
0.16~0.3 in (4~8 mm).
LXN5O508a
(1) Tie rod Nut
► ADjuSTING
If not, loosen nuts at the end of the
cylinder rod on both sides and adjust
the length of the screws. Tighten the
nuts when the toe-in is 0.16~0.3 in
(4~8 mm).
Left and right adjustment of screw
length must be same.
2
1
Br00O729a
(2) Cylinder rod