Pre-Heat Lamp; Pre-Heat Lamp; Battery Charging Lamp; Battery Charging Lamp - Branson 00 Series Operator's Manual

PRE-HEAT LAMP

1 1

(1) PrE-HEAT lamp

Lamp will light on/off depending on
temperature of engine coolant when
main key switch is turned on.
Lamp will be turned off when heater
coil is heated. Start engine after this
lamp is turned off.
It is difficult to start engine in winter
when starting engine before warm up
lamp is turned off. It also causes ear-
ly discharge of battery.

BATTERY CHARGING LAMP

LXN5O419A
(1) Battery Charge Lamp
It will be turned on when the key
switch is put into the "ON" position,
and will be turned off when the battery
starts being charged after engine is
started and the engine revolution in-
creases. The battery will not be
charged with the engine below 1,000
rpm. (The rpm should be 1,500 rpm
or higher)

ENGINE OIL PRESSURE LAMP

1 1
LXN5O421A

(1) Engine oil Pressure lamp

Lamp will come on when the ignition
switch is put into the "ON" position.It
will turn off when the engine is started.
If this lamp comes on while the en-
gine is running, it indicates a problem
in the engine oil system. Stop the en-
gine immediately and check for prob-
lems.
4
FUNCTIoNS 
-
1 1
4
LXN5O420A