Aux. Hydraulics - Branson 00 Series Operator's Manual

5
0 BRANSON 00 SERIES
-
1. When engaging or disengaging
the implement by moving the trac-
tor, make sure that no one is al-
lowed around the tractor or be-
tween the implement and the trac-
tor.
2. Engage or disengage the imple-
ment on a flat and safe place.
Supply proper lighting at all times
and especially at night.
3. When engaging a heavy imple-
ment, load the weight on the front
to keep the balance of the tractor.
4. When adjusting the implement,
apply the parking brake, switch off
WARNING
•
When the PTO shaft is not in
use, affix the safety cover on
it.
[Otherwise]
There is a risk of getting entan-
gled in the tractor or injured.

AUX. HYDRAULICS

A
(A) Outlet (B) Inlet
Hydraulic block type outlet is use-
ful when adding hydraulic operated
equipment such as front loader, etc.
When implement is attached
1. Remove the block cover.
2. Attach the implement inlet and
outlet.
•
For hydraulic block type out-
let, be sure to use the control
valve "Power beyond type"
with relief valve that has a
C
third line return to tank for the
operation of hydraulic block.
B
•
The "tank" port flow from im-
plement should be connect-
BR00O517A
ed to the located on the right
hand side of transmission
(C) Pump
case.
•
If the implement control valve
has a relief valve, the tank port
flow from implement should
be connected to the port lo-
cated on the right hand side of
transmission case.
NOTE