Troubleshooting; Starter Motor Will Not Crank The Engine; Engine Will Not Start; Engine Runs Erratically - Mercury 200 Sport-Jet Operation & Maintenance Manual

Hide thumbs Also See for 200 Sport-Jet:
Table of Contents

Advertisement

Starter Motor Will Not Crank the Engine

POSSIBLE CAUSES
20‑amp fuse in the starting circuit is open. Refer to Maintenance.
Jet drive is not shifted into the neutral position.
Battery is weak or the battery connections are loose or corroded.
Ignition key switch failed.
Wiring or an electrical connection is faulty.
Starter motor solenoid or the slave solenoid failed.

Engine Will Not Start

POSSIBLE CAUSES
Lanyard stop switch is not in the "RUN" position.
Battery is not fully charged.
Incorrect starting procedure was used. Refer to Operation.
Fuel is old or contaminated.
Fuel is not reaching the engine.
• Fuel tank is empty.
• Fuel tank vent is not open or is restricted.
• Fuel line is disconnected or kinked.
• Fuel filter is obstructed. Refer to Maintenance.
• Fuel pump failed.
• Fuel tank filter is obstructed.
20‑amp fuse is open. Check the fuses. Refer to Maintenance.
Threaded connection of an air hose is loose.
Ignition system component failed.
Spark plugs are fouled or defective. Refer to Maintenance.

Engine Runs Erratically

POSSIBLE CAUSES
Spark plugs are fouled or defective. Refer to Maintenance.
System setup or adjustments were done incorrectly.
Fuel to the engine is being restricted.
• Engine fuel filter is obstructed. Refer to Maintenance.
• Fuel tank filter is obstructed.
• Antisiphon valve on built‑in fuel tank is stuck.
• Fuel line is kinked or pinched.
• Injector is plugged.

TROUBLESHOOTING

66
eng

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents