●
Screw the compressor tyre inflator into the
valve.
●
Repeat the inflation process.
If the indicated pressure still cannot be
●
reached, the tyre is too badly damaged. Stop
and request assistance from an authorised
technician.
●
Disconnect the air compressor. Unscrew
the tyre inflator tube from the tyre valve.
●
When the tyre pressure is between 2.5 and
2.0 bars, continue driving without exceeding
80 km/h (50 mph).
Check the pressure again after 10 minutes
●
›››
page
86.
›››
in TMS (Tyre Mobility System)* on
page 85
›››
page 85
The essentials
Changing a wheel
Vehicle tool kit
Underneath the floor panel of the lug-
Fig. 65
gage compartment: vehicle tool kit.
Adapter for anti-theft bolt
1
Towing eye, removable
2
Box spanner for wheel bolts
3
Crank handle for jack
4
Jack
5
Screwdriver with hexagon socket in the
6
handle
Hook for pulling off wheel trims or wheel
7
bolt caps.
›››
in Location on page 82
›››
page 82
Full hubcaps*
Removing the full hubcap
Fig. 66
Removing the full hubcap
●
Take the wheel brace and the wire hook
›››
from the vehicle tool kit
●
Hook the wire through one of the grooves
on the hubcap.
●
Insert the wheel brace onto the wire hook
›››
Fig. 66
and pull the hub cap in the direc-
tion shown by the arrow.
page
82.
»
45