Seat Alhambra Owner's Manual page 148

Automatic off
The lumbar massage will disconnect auto-
●
matically after approx. 10 minutes.
Seat with position memory*
Fig. 157 Memory buttons on the outside of
the driver seat
Memory buttons
Individual settings for the driver seat and the
exterior mirror can be assigned to each mem-
ory button.
Storing exterior mirror settings for driving
forwards
● Connect the automatic parking brake.
Move the gear lever to neutral.
●
● Switch the ignition on.
Adjust the front seat and the exterior mir-
●
rors.
146
Operation
● Keep the button held down for more
SET
›››
than one second Fig. 157.
● Press the required memory button for the
following 10 seconds. An audible warning
confirms the settings have been stored.
Storing front passenger exterior mirror set-
tings for driving in reverse gear
Connect the automatic parking brake.
●
● Move the gear lever to neutral.
Switch the ignition on.
●
● Press the required memory button.
Select reverse gear.
●
● Adjust the front passenger side exterior
mirror so that you can see, for example, the
kerb area.
The new position of the mirror will be stor-
●
ed automatically and allocated to the vehicle
key that was used to unlock the vehicle.
Activating exterior mirror settings
With the driver door open and the ignition
●
turned off, push the memory button of the
corresponding door briefly.
● OR: with the ignition switched on, hold in
the corresponding memory button until the
memorised position is reached.
To activate the memory function of the vehi-
cle key
Important: a position must be memorised in
the memory.
● Open the driver-side door.
Press and hold any memory button.
●
● Within the following three seconds, push
the button to open the vehicle on the vehi-

cle key. An audible warning confirms the set-
tings have been activated.
Adjusting the wing mirrors for driving and
assigning driver seat settings to a vehicle
key
Activate the memory function of the vehicle
●
key
● Adjust the front seat and the exterior mir-
rors.
● Lock the vehicle. The settings are assigned
to the vehicle key.
To deactivate the memory function of the ve-
hicle key
Important: a position must be memorised in
the memory.
Press and hold the button.
●
SET
● Within the following 10 seconds, push the
open button on the vehicle key. An audi-

ble warning confirms the settings have been
deactivated.