Checking engine oil level
Fig. 241
Marked engine oil dipstick
Fig. 242
In the engine compartment: Engine
oil filler cap.
Read the additional information carefully
›››
page 39
Preparations
Park the vehicle on flat ground so that the
●
engine oil reading is correct.
274
Advice
●
Stop the engine and wait a few minutes for
the oil to drain back into the sump. When the
engine has cooled down, immediately check
the oil level and top up if necessary.
›››
●
Open the bonnet
page
269.
●
The engine oil filler neck can be recognised
›››
by the symbol on the cap
the dipstick by its coloured handle.
Checking the engine oil level
Pull out the dipstick and wipe it on a clean
●
cloth.
●
Replace the dipstick, pushing it in as far as
it will go. If the dipstick has a mark, when you
reintroduce it this mark should slot into the
corresponding groove located on the upper
end of the tube.
Remove the oil dipstick again and check
●
the engine oil level.
After reading the oil level, replace the dip-
●
stick in the tube completely.
Adding oil after checking the level
Only add engine oil in small quantities and in
steps:
●
Unscrew the cap from engine oil filler neck
›››
on the cylinder head
Fig.
242. If you are
not sure where the cap is, request help from
a specialist.
●
Only refill using approved SEAT engine oil
in small quantities (no more than 0.5 l)
›››
page
273.
●
To avoid adding too much oil, each time
you add a quantity, wait until the oil has flow-
ed into the crankcase so that it can be meas-
ured with the dipstick.
Fig. 242
and
●
Check the oil level before adding any more
oil. Do not top up with too much engine oil
›››
.
When the oil level is at least in the
●
›››
Fig. 241
B
the tube fully to avoid engine oil escaping
when the engine is running.
After topping up the oil, ensure that the
●
cap is screwed on to the filler neck correctly.
WARNING
Oil could catch fire if it comes into contact
with hot engine components. This could lead
to a fire, explosion and severe injuries.
Always ensure that after topping of oil, the
●
engine oil filler cap is correctly tightened.
This will avoid engine oil spilling onto hot en-
gine parts when the engine is running.
CAUTION
If the engine oil level is above the area
●
›››
Fig. 241
A
specialist assistance. Otherwise catalytic
converter and engine damage may occur.
zone, insert the dipstick into
do not start the engine. Seek