Seat Alhambra Owner's Manual page 94

Control lamp

It lights up
A vehicle exterior
lighting bulb is not Replace the faulty bulb.
working.
Several warning and control lamps light up
for a few seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
Checking the bulbs of a trailer
For vehicles with the factory fitted towing
bracket, certain trailer lights are also control-
led if the power socket is correctly connected.
A fault on a trailer turn signal is indicated on
the instrument panel by the turn signal blink-
ing twice as fast ( or )
● General fault of all turn signals on one side.
Fault in one rear light (on some models, al-
●
so the registration light).
Fault in two brake lights.
●
WARNING
Observe the safety warnings
and warning lamps on page
92
Note
A fault in the LED on the rear lights will not be
indicated. However, if the fault affects all the
LEDs then this will be indicated by the control
lamp .
To replace halogen headlight bulbs
Fig. 106
›››
page 128.
hand side headlight lining.
headlights,
main beam headlights and side lights
›››
in Control
105.
Emergencies
In the engine compartment: left-
dipped beam
A
daytime driving lights and
B
Left headlight.
Fig. 107
There is no need to remove the headlight to
replace bulbs.
Complete operations only in the sequence
given:
Turn signals (small bulb holder)
›››
1. Open the bonnet

2. Rotate the bulb holder
and pull it out backwards together with the bulb.
C
3. Depending on the model, the bulb is removed di-
rectly from the bulb holder or it may need to be ro-
tated and then removed.
4. Replace the faulty bulb with a new identical bulb.
5. Place the bulb holder in the headlight and rotate
to the right all the way.
Dipped beam and daytime lights
A
›››
1. Open the bonnet

page 269.
to the left all the way
1
B
page 269.