Seat Alhambra Owner's Manual page 182

An optimum range is obtained by keeping
the remote control vertical, with the aerial
›››
Fig. 197 pointing upwards. When doing
A
so, do not cover the aerial with your fingers
or with the palm of your hand.
There must be a minimum distance of 2 me-
tres between the remote control and the vehi-
cle.
CAUTION
● The radio frequency remote control con-
tains electronic components. Therefore, avoid
getting it wet and being knocked and protect
it from direct sunlight.
Use of inappropriate batteries may damage
●
the remote control. For this reason, always re-
place the used battery with another of the
same voltage, size and specifications.
For the sake of the environment
Please dispose of old batteries so that they
●
do not harm the environment.
● The remote control battery may contain
perchlorate. Observe the legal requirements
for their disposal.
Programming the auxiliary heater
The heater or ventilation inside the vehicle
can be programmed for a certain period.
180
Operation
Before programming, check that the day is
correctly set in the Auxiliary heater -
›››
day of the week menu
Enabling the Auxiliary heater menu on
the instrument panel
From the main menu, select the Auxili-
●
ary heater submenu and press the
button on the windscreen wiper lever.
● OR: press the or arrow buttons on the
 
multifunction steering wheel until the Aux-
iliary heater menu is displayed.
Menu op-
Description
tions
The auxiliary heater can be set to come
on automatically if required. To do so,
select a timer:
– The timer is displayed marked with a
.
Switching
– Only one timer can be selected. If a
on
timer has been selected,
Switching
will be displayed on the screen. If no
off
timer has been selected, the dash
panel display will show
– To modify the programmed timer, se-
lect another timer or select the
option.
Three different timers (hh.mm) can lat-
er be selected using the
Timer 1 the auxiliary heater is to be switched
on for just a certain day of the week,
Timer 2
Timer 3 select the day of the week and the
time for the auxiliary heater to come
on.
Menu op-
tions
.
Duration
Operating
OK
mode
Day
Factory
settings
Back
Checking programming
If the timer has been switched on after
switching the ignition off, the light on button
will remain lit for around 10 seconds.

WARNING
Prog. ON
Never program the independent heating sys-
tem to be activated and operated in closed,
.
Prog. OFF
unventilated areas. The auxiliary heater
fumes contain carbon dioxide, an odourless
Off
and colourless toxic gas. Carbon monoxide
can cause people to lose consciousness. It
can also cause death.
On option. If
Description
The operating time may vary between
10 and 60 minutes and can be set to
5-minute intervals.
Set to heat or ventilate the vehicle in-
terior when the auxiliary heater is
switched on.
Set the current day of the week.
The predefined factory values for the
functions of this menu are restored.
This returns to the main menu.