Operation; Packaging, Transport And Storage - Vega VEGABAR 17 Operating Instructions Manual

Process pressure transmitter with metallic measuring cell
Table of Contents

Advertisement

3 Product description
Functional principle
Voltage supply
Packaging
Transport
Transport inspection
Storage
Storage and transport
temperature
8
The process pressure acts on the sensor element via the stainless
steel diaphragm. The process pressure causes a resistance change
which is converted into a corresponding output signal and outputted
as measured value.
1)
4 ... 20 mA two-wire electronics for voltage supply and measured
value transmission on the same cable.
3.3

Operation

The VEGABAR 17 has no adjustment options.
However, there are two built-in potentiometers for recalibration of zero
and span.
3.4

Packaging, transport and storage

Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
based on ISO 4180.
The packaging of standard instruments consists of environment-
friendly, recyclable cardboard. For special versions, PE foam or PE
foil is also used. Dispose of the packaging material via specialised
recycling companies.
Transport must be carried out in due consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or con-
cealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and
stored according to the orientation and storage markings on the
outside.
Unless otherwise indicated, the packages must be stored only under
the following conditions:
Not in the open
Dry and dust free
Not exposed to corrosive media
Protected against solar radiation
Avoiding mechanical shock and vibration
Storage and transport temperature see chapter "Supplement -
Technical data - Ambient conditions"
Relative humidity 20 ... 85 %
Measuring ranges up to 16 bar: piezoresistive sensor element with internal
1)
transmission liquid. Measuring ranges up to 25 bar: strain gauge (DMS) sen-
sor element on the rear of the stainless steel diaphragm (dry).
VEGABAR 17 •

Advertisement

Table of Contents
loading

Table of Contents