Vega VEGABAR 17 Operating Instructions Manual page 13

Connection via angle
plug connector with
hinged cover
VEGABAR 17 •
1
Fig. 4: Connection to the screw terminals
1 Cable gland
2 Plug housing
3 Plug insert
4 Plug seal
7. Snap the plug insert into the plug housing and insert the sensor
seal
8. Plug the plug insert with seal to VEGABAR 17 and tighten the
screw
The electrical connection is finished.
Proceed as follows:
1. Loosen the screw in the cover of the plug connector
2. Open the cover and remove it
3. Press the plug insert downwards
4. Loosen the screws of the strain relief and cable entry
1
Fig. 5: Loosen the plug insert
1 Plug insert
2 Strain relief
3 Cable gland
4 Plug housing
5. Remove approx. 5 cm of the cable mantle, strip approx. 1 cm
insulation from the individual wires
6. Lead the cable through the cable gland into the plug housing
7. Connect the wire ends to the screw terminals according to the
wiring plan
5 Connecting to power supply
2
1
3
2
4
2
3
4
3
13