Connection Procedure - Vega VEGABAR 17 Operating Instructions Manual

5 Connecting to power supply
Select connection
cable for Ex applica-
tions
Connection via angle
plug connector
12
This can lead to unacceptably high currents in the cable screen if it is
grounded at both ends.
Information:
The metallic parts of the instrument (process fitting, housing, etc.) are
conductively connected to the ground terminal.
Take note of the corresponding installation regulations for Ex applica-
tions.
5.2

Connection procedure

Proceed as follows:
1. Loosen the screw on the rear of the plug connector
2. Remove the plug connector and seal from VEGABAR 17
3. Remove the plug insert from the plug housing
Fig. 3: Loosen the plug insert
1 Cable gland
2 Plug insert
3 Plug housing
4. Remove approx. 5 cm of the cable mantle, strip approx. 1 cm
insulation from the individual wires
5. Lead the cable through the cable gland into the plug housing
6. Connect the wire ends to the screw terminals according to the
wiring plan
3
2
1
VEGABAR 17 •