MakerBot Replicator Mini+ User Manual page 5

Safety alert symbols precede each safety message in this manual.
These symbols indicate potential safety hazards that could harm
you or others or cause product or property damage.
Warning: The MakerBot Replicator+ 3D printer generates high temperatures. Always allow
the MakerBot Replicator+ Smart Extruder+ to cool down before you reach inside.
Warning: The MakerBot Replicator Mini+ includes moving parts that can cause injury. Never
reach inside the MakerBot Replicator Mini+ while it is in operation.
Warning: The MakerBot Replicator Mini+ generates high temperatures. Always allow the
Smart Extruder+ to cool down before you reach inside.
Warning: There is a risk of shock. The MakerBot Replicator Mini+ is not user serviceable.
Caution: Do not leave the MakerBot Replicator Mini+ unattended during operation.
Caution: Do not print using materials that have not been approved by MakerBot for use with
the MakerBot Replicator Mini+.
Caution: The socket outlet must be located near the machine and must be easily accessible.
Caution: In case of emergency, disconnect the MakerBot Replicator Mini+ from the socket outlet.
Caution: The MakerBot Replicator Mini+ melts plastic during printing. Plastic odors may be
emitted during this operation. Make sure to set up the MakerBot Replicator Mini+ in a well-
ventilated area.
Caution: Never remove the Smart Extruder+ from your MakerBot Replicator Mini+ or turn
off the MakerBot Replicator Mini+ during or immediately after printing. Always allow the
Smart Extruder to cool completely before removing it from the MakerBot Replicator Mini+ or
turning off your 3D printer.
Caution: Do not look directly at any operating LED component.
Caution: Children under 12 should be supervised by an adult.
Caution: Dust generation and accumulation should be minimized. Some dust and dry
powders can build static electricity charges when subjected to friction and create an ignition
hazard.
WELCOME, LET'S GET STARTED 5