Table of Contents
Advertisement
INSTALL THE SPOOL OF MAKERBOT PLA FILAMENT
GETTING STARTED
12
1.
Locate the MakerBot PLA Filament spool and
remove it from its plastic bag.
2.
Lower the filament spool into the Filament Spool
Pocket, making sure that the filament windows on
the spool are facing you.
3.
Pinch one end of the filament and feed that end of
the filament through the white filament guide tube
until a small amount of filament comes out of the
other end.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Replicator Mini+ and is the answer not in the manual?