Table of Contents
Advertisement
SETTING UP THE REPLICATOR MINI+
INSTALL THE SMART EXTRUDER+
Press the Smart Extruder+ against the back of the extruder carriage, with the connector pins facing the
extruder carriage. Magnets will lock the Smart Extruder+ into place.
Caution: Never remove the Smart Extruder+ from your MakerBot Replicator Mini+ during or
immediately after printing. Always allow the Smart Extruder+ to cool completely for five to ten
minutes before removing it from the 3D printer.
GETTING STARTED
11
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Replicator Mini+ and is the answer not in the manual?