Dimplex RBF30 Service Manual page 4

Icon Function
Heat Enable
Heat Disable
Color
E
Themes
F
360 Light
o
G
Brightness
H
Flame
Light
I
Sensor
J
Timer
Control Lock
Control Unlock
Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on without being reset. It
can be reset by disconnecting power at the main electrical panel and waiting 5 minutes before plugging the unit back in.
CAUTION: If you need to con tinuously reset the heater, unplug the unit and call technical support at 1-888-346-7539.
4
Description
Hold both Heat ( ) and Temp– (
on the screen.
Hold both Heat ( ) and Temp– (
adjusted "---" displays on the screen.
Press multiple times to change the flame base colors from Red to Blue to Off. (The first
segment on the display will change from "r" to "b" to blank) This feature is active only
when the flame effect is On.
Press multiple times to change the LEDs on the sides and back of the unit from Midnight
mode to white to yellow to red. (The middle segment on the display will change through
0 - 3 respectively. This feature is active only when the Flame is ON.)
Press to change the LED lights from High to Low. (The last segment on the display will
change from "H" to "L") The Realog
flame effect is Off.
! NOTE: When the Light Sensor is activated, High and Low flickering brightness
settings are also available (Flashing "H" and "L").
Press to light the log set and start the flame effect. Press again to turn feature Off.
Press to activate the ambient light sensor (ALS ON). Press again to turn the sensor off
(ALS OFF).
!
NOTE: The light sensor will adjust the brightness of the fireplace based on the
ambient light in the room.
Press multiple times to change the sleeper timer in 0.5 hr increments from 0.5 hr to 8.0 hr
before turning off. The remaining time on the sleep timer displays.
Hold both Temp– ( ) and Brightness (
manual controls.
Hold both Temp– ( ) and Brightness (
manual controls.
), on the unit, for 2 seconds. Temperature displays
), on the unit, for 2 seconds, when temperature is
LEDs remain On when the heater is ON and the
TM
), on the unit, for 2 seconds to disable the
), on the unit, for 2 seconds to enable the
www.dimplex.com